Alloy-computer-products Network Device BWS-136 Bedienungsanleitung PDF herunterladen (Seite 5)

BWS-136 User Manual_amend.doc - 9 -

SW1 Setting:

SW1 Key 1 2 3 4 5

RS-232 ON OFF OFF - -

RS-422 OFF OFF OFF - -

RS-485 OFF ON ON - -

Normal - - - OFF OFF

DHCP OFF ON

Default ON OFF

Console ON ON

Normal: Aport is in Normal Operation Mode

DHCP: Network IP Address is assigned by DHCP Server

Default: All the settings are reset to Factory Default.

Console: COM1 serial port is served as console port. User can

use ACSII command to configure BWS-136 via COM1 port.

Please refer to Appendix I for the ASCII command

Changing the switch settings will not be effective until

system reboot by pressing RESET button

BWS-136 User Manual_amend.doc - 10 -

LED Status

The LED provides the BWS-136 operation information. The

LED status is described as follow:

Power LED: Power LED keeps ON if power (+9VDC to +40VDC)

is correctly input to BWS-136.

Ready LED: Ready LED keeps ON when Aport 211 firmware is

ready for operation. Ready LED will be flash when Aport 211 in

Serial Console mode (SW1 key 4 and key 5 are ON) or Telnet

Console mode (Telnet Console port:5001 are connected)

Link/Act LED: Link and Activity LED will turn ON when the

Ethernet cable is connected. When there is network data traffic,

this LED will be flash.

RX/TX LED: The RX/TX LED is a dual color LED that indicates

the serial data traffic. In RS-232 mode, the Yellow LED stands

for transmitting data and Green LED means receiving data. In

RS-422/485 mode, the Yellow LED stands for receiving data and

Green LED means transmitting data.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Keine Kommentare

Alloy-computer-products Network Device BWS-136 Bedienungsanleitung Seite 5